The extractor arm is a device which allows the user to position a suction hood to capture fumes or dust close the generation spot with complete ease and flexibilty

The extractor arm is a device which allows the user to position a suction hood to capture fumes or dust close the generation spot with complete ease and flexibilty. The extractor arm consists of 2 ducts made of aluminium connected by PVC hose and mounted on interconnecting support rods with friction -loaded pivots.A suction hood is attached to one end.The other end is attached to a rotating hollow cylinder.The suctionhood, ducts, hose and rotating cylinder form a passage for the fumes or dust. The entire arm is self balancing and articulated at 3 points. This allows the suctionhood to be positioned by hand at any point with a reach of 2 meters(or 4 meters) to & fro and 2 meters(or 4 meters) up & down with a complete ease & flexiblity with minimum force. The extractor arm can be fitted to most of our Fumekiller models & Dustbag models. The arm can also be fitted to overhead ducting to provide suction points close to the floor level for the capture of fumes or dust from pollution generation spots.

The extractor arm consists of elements of aluminium ducts joined by flexible hose , articulated at 3 fulcrum points . One end of the arm is fitted with a suction hood and the other end is fitted with a swivel fixture. The arm is self balanced using friction pads and a telescopic gas tube. The arm can be swiveled by hand through about 270 degrees and can be positioned easily within a nominal distance specified for each arm. With the Extractor arm , fitted to the Fumekiller or Dust Bag the suction hood of the arm is to be positioned close to the fumes/dust generation spot. The fumes/dust will be sucked through the suction hood and will reach the Fumekiller or DustBag for filtration.

"Extrakt Arm" Specifications for Extractor Arm Models FEA-160-2 FEA-200-2 FEA-200-4 FEA-250-2 Mini Arm AirFlow Capacity 1500-2000 cu mtrs/hr 2000-2500 cu mtrs/hr 2000-2500 cu mtrs/hr 3500-4000 cu mtrs/hr 250 cu mtrs/hr Total reach(Approx.) 2 mtrs up, down 2 mtrs up, down 4 mtrs up, down 2 mtrs up, down 0.5 M with in   2 mtrs forward, back 2 mtrs forward, back 4 mtrs forward, back 2 mtrs forward, back 250 degree swivel Construction Aluminium ducts Aluminium ducts Aluminium ducts Aluminium ducts Structured Aluminium   160ø x 2nos . 200ø x 2nos. 200ø x 2nos. 250ø x 2nos. Frames with 3 nos of   Interconnecting Interconnecting Interconnecting Interconnecting friction pivots and   PVC Hose,with PVC Hose,with PVC Hose,with PVC Hose,with provided with  table   Steel Wire rib. Steel Wire rib. Steel Wire rib. Steel Wire rib. mount clamp.   Telescopic gas tube Telescopic gas tube Telescopic gas tube Telescopic gas tube Flexible hose 100ø  x 1   Damper Damper Damper Damper     Friction pads with disc Friction pads with disc Friction pads with disc Friction pads with disc     spring for all pivots. spring for all pivots. spring for all pivots. spring for all pivots.     FRP suction hood FRP suction hood FRP suction hood FRP suction hood FRP suction hood   with handle with handle with handle with handle   » Due to continuous innovation, specifications are subject to change without notice. » The above extractor arms can be fitted on some models of Fumekiller & Dust Bag equipment depending on the air flow capacity.